@mikep wrote:
Here’s the majority of clamping kit of stuff I use all the time with my machine. The Suckit “oops” clamps just replaced some other rockler sourced camps. There are a few other clamps, but they’re more special purpose (some t-track stuff for side clamping, mostly)
Stuff that’s in there:
Shoulder bolts, several lengths
1/4-20 screws for the oops clamps
suckit “oops” clamps (I really like these, will see how they hold up)
Washers for the screws
Various dowels - some fit the table, some are for hold-down along the sides of material.
[two short dowels in the pin holes in the board, long dowel against that, then a cam clamp from the other side, part won’t lift off the table when clamped]
Big ball bearings - again, side hold-down without lift.
A few quoins (brass, jaggy looking ramps on the right)
Posts: 1
Participants: 1