@cgallery wrote:
I upgraded to the latest version of Cut2D Desktop thinking it would do array copies of cutting paths. That is a new feature and only available in Pro (+ $300).
So I got to wondering if there are any alternative senders that could produce an array of the same part.
I’m thinking something that would allow me to specify the source file, and the array size (like 2x3) and the gap to leave between parts for x and y.
So then the software would send the file, and then jog the specified amount and send the file again. Rinse. Repeat.
Anything out there to do something like that? I actually drive my machine with an older version of UGS (Ultimate Gcode Sender) and I don’t think it can do it, but I could be wrong.
I previously used an older version of Carbide Motion , don’t think it could do it, either.
Ideas? Other suggestions?
Posts: 11
Participants: 7