@markmoran wrote:
I just received the C3D Touch Probe and am interested in using it to make two-sided milling easier. Is it possible to have CM4 probe a corner other than the bottom left one? I would think if it could probe the bottom right corner as well, I could flip over my work piece and have it re-set zero perfectly without having to use dowels? Or am I missing something dumb or obvious? I guess you could probe the bottom left corner both times, but that would require that the stock be perfectly measured and put into Fusion 360, right? In the past I haven’t worried about the stock size much in Fusion, I just model holes on either side of the object and have the Shapeoko drill them right into the wasteboard, which I then insert dowels into when I flip over the piece. That works pretty well, but of course is only as precise as my dowel-hole tolerance. But I’m thinking this can be easier and more accurate with the probe?
Thanks for any advice.
Posts: 1
Participants: 1