@aarongblack wrote:
I just finished setting up my new XXL and connected the machine to my laptop. I go into Carbide Motion and go to the MDI module and enter the phrase “type $22=1 to enable homing, press the Send button to write the change” as stated in the directions to home the machine. When I hit send nothing seems happens. I then entered $H because the directions seem to indicate that’s a phrase used for home as well and then I get this message “limit switch hit”. The machine isn’t moving or doing anything, other than making a humming sound. I centered the XZ assembly and carriage but that didn’t seem to change anything. Please advise? I’m stumped.
Posts: 8
Participants: 4