@cnicho35 wrote:
Hi everyone! First post here after a while of lurking. Sorry in advanced if this question has already been asked but I couldn't find an answer on these forums...
So after using my nomad for a while and being somewhat disappointed by the default feeds and speeds for different materials I would like to add my own material feed and speeds for different materials and tools. Does anyone know if this is possible with the Carbide Create software and how I could go about doing it? I know I could go through and edit the parameters of my cuts in the Toolpath tab but life would be much better if I could just configure my own materials in the job setup page and then all my cuts would be automatically updated when I make a change to the universal parameters.
Glad to be participating in the community! Thank you in advance!
-Casey
Posts: 2
Participants: 2
