@Zoomer wrote:
My Carbide Create and Carbide Motion were running just fine until an automatic update from Microsoft for my Windows 10 system was installed. Now I can run either program until I try to run the other when I receive either of 2 MS error messages and I cannot run the programs until I reinstall them.
Carbide Create delivers the attached message...
Carbide Motion delivers this message:
Carbide Motion has stopped working.
A program caused the program to stop working correctly. Windows will close the program and notify you if a solution is available. (Nothing is suggested)Very annoying... any suggestions would be appreciated!
Thank you!
Don
Posts: 5
Participants: 3
