@chendreid wrote:
Hi There,
I have a bit of a unique situation here. Please excuse my ignorance, I am fairly new to CNC. Today I was running a complex 3D job on my nomad and working on another project on the side. Long story short I slipped with a knife and cut my thumb all the way to the bone. I haven't gotten to the point where I feel confident enough to run a job while I'm not there, so I put some gauze on my cut, paused the job in carbide motion, took a picture of carbide motion to capture the line of g-code and the x,y, and z position of the cutter, quit the job, and left for the hospital. Given the fact that I have all of that information, is there any way that I can restart my job from the line of g code and x, y, z, coordinates where I left off? Thanks! I appreciate your help!
Posts: 2
Participants: 2