@JFischer911 wrote:
Hi All,
I'm trying to perfect a logo I'm working on for a project and I think I'm about there. I'm really happy with the effect I get with the two layers of veneer on top of the white maple but I can't figure out how to eliminate the tear out in the maple that you can see in some areas. (I know maple tears out easily anyway) I'm using a brand new 1", 2 flute V bit at 30 in/min, plunge of 15 in/min.(A previous experiment burned a little when I went slower at 15 in/min.) and the Dewalt 611 set a the lowest speed setting. I also tried doing a second pass with the Z set 1 or 2 thousands lower than the first to act like a final pass without much change. I used VCarve Pro for the toolpaths and I don't see a way to do final pass or climb cut with the V carving toolpath.
Any help you guys might be able to provide would be appreciated!
Posts: 5
Participants: 4