MeshCAM v6 toolpath is making a lot of unnecessary surface cut

@ttumkaya wrote:

I've been trying to cut a piece which has parts in 3 different depths: 1.5mm ,1mm and 0mm.

For some reason, MeshCAM toolpath is doing parallel finish on all the surface area. And when I switch the parallel finish off, it does not cut the surface which has to be cut (1.5mm in depth). I'm attaching screenshot for the settings and an .stl file of my design.

Any help is greatly appreciated!
Thanks,

MeshCamSettings.png1920x1080 395 KB

OSAR 16 chambers_flyLayer .STL (118.4 KB)

Posts: 2

Participants: 2

Read full topic