@Jamied wrote:
Hey guys...looking for some help on one issue I seem to keep having with my xxl. so, I turn on the power to the controller, go through the homing sequence and all is good. I rapid position to the current x,y, location (I have index pins so this doesn't usually change) still all is good. However, then I go to set the Z axis Zero (of course this changes with material thickness) by moving the plate down to the right depth and hit zero. now, If I try any jogging in any other way than using rapid position commands, it just takes off to the Machine home (Back right) usually scraping my material, potentially bending my bit, and smashing any clamps that are in the way.....then I hit load, or turn off the power just to stop the choas, and either operation causes me to have to go through the homing sequence again. Now, being someone who knows nothing about coding, is there something written in behind the scenes to make this happen? it seems any time you zero any axis, then try to jog manually, it does this. Is there a way to fix this aside from turning off the homing? I usually just hit z zero+6 and try to get where I need to using the rapid positioning, but, sometimes I want to fine tune where the job starts from. please help.
Posts: 12
Participants: 5
