More than a strange behavior

@darkwingduck wrote:

Hi all, and thanx taking my up in the community ;o)
I assembled my Shapeoko 3 XXl successfully.
I was running the 'Hello World' as suggested.
Homing was ok. The result was bad due to leveling of the Z-axis.
No hassle.
The first run was basically ok, but then...
Repowering everything, leveling Z, and trying to rerun.
Homing: None off the axes where moving, nothing.
Ok, so switching off the end switches by sending $21=0 and setting $20=1
This brought me back to jog without mandatory homing.
Next step: Repower and restart my Mac, launch Carbide Motion (3.0.361)

Powerup results of the Shapeoko:
X-axis : can be moved freely
Y-axis : holds position, not moveable
Z-axis : can be moved freely

Ok, try to jog the axes within Carbide Motion (3.0.361):
X-axis : moves as expected, but not holding position when I push manually
Y-axis : moves as expected and holding position, even on manual push
Z-axis : Holding position when pressed, but, when clicking to jog Z+/Z-, the axis is always moving downwards...

Lost in space...

Any help or directions appreciated.

Posts: 2

Participants: 2

Read full topic