@TX_SGT wrote:
HELP ME!!!. Ok so I’m working on a project, and the first cut is a .125 pocket with a .25 endmill. I checked, double checked, and triple checked the settings. Start is at 0 on top of board, stock size is set correctly. Machine is zeroed out correctly on top of board. I run the toolpath, and instead of cutting at .125 it does all the way down to almost .500. Here is a sample of the code it is Shapeoko (inch) post processor using Vcarve pro. Looking at it everything seems correct. the (G1Z-0.125.F50.0) command is the depth of the cut correct? Why is the machine doing this? tried the GRBL (Inch) processor too, and same thing. Any ideas. First time this has happened to me .
T1
G17
G20
G0Z1.0100
G0X0.0000Y0.0000S12000M3
G0X13.3550Y0.7800Z1.0000
G0Z0.2000
G1Z-0.1250F50.0
Posts: 8
Participants: 5
