@MrBeaver wrote:
Hi guys
I’m doing a big job on a largish sheet of aluminium (50x50cm), I’m uing the tried and tested superglue and tape method which is great.
Spreading that much glue over such an large area I was getting a bit
loosygoosy. The parts I’m cutting out are quite small 3x5cm or so and there are lots of them.
Are there any better methods of hold down that I might not be considering. It’s a good 10 min after my glue up and I’m still in a strange place
Luke
loosygoosy. The parts I’m cutting out are quite small 3x5cm or so and there are lots of them.
Posts: 8
Participants: 7