@Alderic23 wrote:
I don’t know if it’s a problem with my end mill, my machine setup, or just my luck. I don’t know what to do to fix these uneven edges. Does anyone have suggestions?
Here are my specs:
- 8 IPM Feed & Plunge
- Makita dial 1.0
- (tried a 30 IPM, dial 3.5, but same result)
- Carbide3D 0.50" V-Bit Cutter - 90°
- Shapeoko XL
- Carbide Motion
- Fusion 360
- MDF wood (with veneer on top)
- Secured with double sided tape (Intertape 591)
Posts: 6
Participants: 6