@ItsDan wrote:
I’m mostly just venting here, I wasn’t watching right as the cut got messed up so I’m left unsure what happened. The board came loose during the cut but I think it came loose because it tried to do a lead in at full depth. The second issue I see is it clipped the corner but I suspect that occured because the piece had shifted. What’s strange is I don’t have leads turned on for that section, I have a ramp but the erroneous cut isn’t ramped. So, sigh. Going to isolate that part of the cut and try and air cut to spot what might have happened, and I’ll turn off the ramps for now.
Posts: 1
Participants: 1
