@Croy9000 wrote:
I am putting together my new Shapeoko 3 XXL and have an issue with the Idler Assembly (I think). Here is a picture of the part I am talking about from the online guide:
![]()
It appears that the bolt should be able to slide in the slot of the X Carriage (correct me if I am wrong). But in my case the the bolt (which was preinstalled despite the guide saying you install it yourself) is super super tight in the slot. Clearly whoever assembled it had to actually screw it into the slot (not slip it in). I tried filing down the powder coating buts its going to take a lot more filing than that for it to be able to move at all.
Before I go filing and messing something up. Is this expected/normal? Its going to take a lot filing to get it corrected.
Posts: 3
Participants: 2