Cutter Did Not Respond - Requires Reflash to Run

@Dill wrote:

Having a challenge since I recieved the machine, figured I was doing something wrong … haven’t figured it out

Order of operations:

• (1) Start laptop (Win10)
• (2) Start Shapeoko3
• (3) Wait for Shapeoko to boot
• (4) Open Carbide Motion
• (5) Connect to Cutter … Connects
• (6) Initialize Machine
• Then I get an error “Cutter Did Not Respond” and I can’t get anything after this

Now …
If I run Carbide Updater between ops 3 and 4 - the whole process works no issue, machine responds, jogs, runs jobs, no issue … but every time I turn off/on the Shapeoko I need to run this step

Looking for any ideas of where I am going wrong here …

Posts: 2

Participants: 2

Read full topic