@SteamMaker wrote:
This is Melody. I’m assisting Michael with this issue. The computer was recognizing the cutter last night. Michael even ran a test cut successfully. This morning, it is no longer recognizing it. He is planning to connect the DeWalt router to a different circuit since that may be an issue. However, nothing can be done if the computer will not recognize the Shapeoko 3 board. We have removed and reinstalled the Carbide software and rebooted the computer, but still nothing. I have checked that the wires are connected properly and switch is turned on. The board is on – blue light is on. When I turn on the power switch, there is a short buzz of the motors and then a soft hum that continues. So, it’s on. After this I check my computer Device Manager. Nothing showing in the port like it was yesterday. So, of course, when I turn on the Carbide software and press Connect, I receive the error message:“GRBL Error: Cutter not found”.
I have experience programming Arduino and have many spare boards if it will be necessary to do something with the board.
Please assist us with resolving this issue. Thank you!
Posts: 3
Participants: 2