@lxkhn wrote:
I got bCNC all setup (because I wanted to use something with a WCS) and everything seemed to be going fine, I set the x,y,z for G54 moved it off and issued command to send it back, works perfectly....
Then I try and run some Gcode and when it starts it send the gantry all the way back to the home location in the top right triggering the one of the switches..... what am I doing wrong? Why is it not using my new zero on G54? Is there a secondary (or primary) 0 you have to set outside of the WCS setup?
Posts: 12
Participants: 5
