@Ton80 wrote:
I am searching but not finding if there is a list of all the tooling data from Carbide that I can enter into VcarveP. I’ll keep looking.
Maybe the best thing to do is set up a job in Create and just copy paste the info over so I have a custom group in my Vcarve database? Or maybe since I don’t have anything outside of the .125 and .25 EM and some V-bits with standard 60/90 angles it is fine to just use the tool list in VCarve?
I was looking for to verify the speeds/feed rate and plunge rate info as suggested by Carbide since I am using their machine, just not their software.
Posts: 4
Participants: 2