@Blackjack wrote:
Well this weeks project is almost complete. I installed the T-Track system and waste board on my new base for the XXL. Is there a prescribed method to replace the base without disassembly of the entire machine? This is what I was thinking:
- Loosen and remove M5 x 25mm BHCS.on MDF base
- Loosen (16) BHCS for Y 1 and Y 2 extrusion.
- Remove MDF base
- Slide new base into position from Y2 side
- Align new base to hole pattern and reinstall M5 BHCS
- Resquare and tighten the 16 BHCS on the ends of the Y1 and Y 2 extrusion
- Recalibrate
Thanks in advance for your thought!!
Posts: 1
Participants: 1