@shashster wrote:
So I pulled the trigger and am impatiently waiting for my Shapeoko 3 to ship and arrive (It’s been a week already I just might explode with anticipation). Just wondering if I could solicit some advice from the community.
I’ve decided to build an enclosure mainly for sound and dust concerns. Wondering if 30"x30"x24" is enough room on the inside for the machine to sit and run comfortably?
I have some Whiteside spiral bits already that I love to use and wondering if these are good for CNC work or if I should buy some from the Carbide shop instead?
I also sprung for a suckit dustboot and was looking for a good dust hose recommendations? I have some nice ones from Rockler that I like but didn’t know if it would be too heavy or not.
Any youtubers or other content creators you would recommend as great learning resources?
Thanks so much. I’m looking forward to this CNC adventure and being a part of the community here which as a lurker has already been super informative!
Posts: 4
Participants: 3
