@kenpurzy wrote:
I just got my Shapeoko 3 and assembled it as per the Guide. For the most part everything when along as described except for squaring the Gantry.
When I bring the gantry to the front the left side abuts the Y bracket but the right side is about 0.125 in from the Y bracket. When I move it to the rear the right side abuts the Y bracket and there is a 0.125 ’ gap on the left. I followed the guide instructions several times to the letter as described on pg 43 & 44 of the guide. I also loosened all 16 screws in the base, 16 Y rails and 8 X rail. I repeated the squaring recommendations but still not been able to square the gantry as described in the guide.I checked the Forum and it seems that several have also had the same issue and recommended several fixes ranging from disassembling and resembling to adding foil spacers on y rails.
Has any one at Carbide3d reviewed the problem and recommended a fix?
Or is the 0.125 gap acceptable??
Any one got any recommendations?.
Posts: 2
Participants: 2