@Blackjack wrote:
Ran in to an issue today. Was Doing some cuts in 3/4" plywood today First job everything went as planned. Set up next job use the probe to Zero all using the probe. Probe cycle went fine then clicked run and it ran the entire job about 10 mm above the zero. Tried running different files to cut same thing. I used the jog feature to jog the endmill back down to the work surface and the Z was -10. I did then use the same file in question and rezeroed Manually on the work surface and the job ran perfectly. anyone got any ideas why and how to rectify?
Posts: 2
Participants: 2