@Jamesrs wrote:
Hello,
Today I finally had the chance to flash the board for the new version 4 software and probe.
I managed to get through that even after the flashing the z axis was reversed for some reason.
I changed the parameter for that and it was good, proceeded to the probe part. I have the newer board so it was basically plug and play except I didn’t receive the alligator clip and cable.
I made up a quick one to test the probe, I followed the probe use instructions and it throws up and error failed. Well I moved on to just test out the V4 software, I like the fact to be able to change the feed rate. Except after completing my file this pops error pops up now, and I cannot duplicate projects
Posts: 2
Participants: 2