@samichi wrote:
I’m a beginner and made my first cut/test with good results. I just etched my name in a block of wood, using Carbide Create. Realizing the limitations, I’m trying to learn Fusion 360 for the CAM capabilities. There are so many numbers it gets confusing. I’ve tried my best to match numbers I’ve found in the forums and the wiki pages.
Can anyone check these numbers and tell me if everything looks alright? Just want to check here first before I send it to the machine.
I’m cutting a letter out of 1/2" pine board. I’m using the Makita with the stock bit that came with machine. It’s contour cut with tabs on the bottom. Any suggestions would be helpful. Thanks
Posts: 1
Participants: 1