@spasmfingers wrote:
I know there have been dozens of good suggestions for carbide create already, and that it takes an enormous ammount of time and effort to add them, but I figure I might as well add to the overflowing plate.
I photoshopped in a few of my ideas here, in case my words fail me.
1: An option to/not to display tool paths when in the “toolpaths” tab. (left)
-If you have a bunch of toolpaths, the program becomes very slow. But when you go to the “design” tab and the paths don’t show, it runs fast. This is why I think turning off the display would work to fix this issue.
-Toolpaths can make it hard to see your design. This can make it hard to select the line you want to assign the next toolpath to.2: Move operation all the way to the top or bottom. (right)
-If you have a ton of operations and then realize you would like to add one neat the top, its rather annoying to click “Move Operation Up” twenty times. Honestly this one doesn’t matter all that much, but it would be nice.3: “Are you sure you want to exit?” (not in image)
-I’m in the habit now of saving after each little thing I change because I have previously closed the program on accident and lost tons of work.
Posts: 3
Participants: 3