@Blackjack wrote:
I have been using the .125 inch ball end-mill for my carving projects(Medium Hardness Balsa and Paulownia) and remembered I had purchased a .25" ER-11 Collet and Nut. I would like to try using one of the .25 x.25 End-mills that I recently purchased to cut some projects with. Will this speed up my cut times? Also When running jobs I have been utilizing the Carbide Auto Toolpath function in Meshcam to set up . (the 1/4" endmills are not listed in the Auto toolpath function, even though I have the other cutters listed in my tool crib in Meshcam.
Posts: 3
Participants: 3