@irr1449 wrote:
So this is a 2 part question. Thanks again to everyone, the support on this forum and from Carbide3D overall has been great.
1) I can't seem to get rid of this artifact on some cuts. http://imgur.com/a/Dg1w4
I've tried to slow down my plunge rate and feed rate. I've adjusted the speed on my router (faster and slower). Any suggestions?
2) Over the last 1-2 days my Z axis has been skipping when it first enters a cut. I'll have to stop the job, reset the Z (as it's now about 3-4mm higher than it was before) and start over. The X,Y are fine so it's not a huge issue.
I've had my machine for awhile. Do the belts need to be replaced at some point?
Posts: 3
Participants: 3