@akobrandon wrote:
Hi if I am using meshcam and am doing a simple job with a roughing and finish pass. Halfway through the finish pass I broke a bit.
Is there any way to replace the bit and resume? Or do I have to start the job completely over again?
If I have to start it over again what is the process? Can I regenerate the toolpath and skip the roughing (since I already completed that) and just start the finishing path again? If I do that then as long as I don't reset the machine 0 it should maintain the 0'ed axis from the previous job right?
Thanks for your help
Posts: 5
Participants: 2
