@dbrozek wrote:
Hi,
I'm baffled by a recently noticed problem with carving curves with our shapeoko3 running CC and CM. I get a slight jump up the Y axis when I get about 330degrees through a circle. Doesn't matter where on the bed I operate or the radius, so probably not steppers? I designed the circle in CC and also tried importing a dxf and svg of a circle done in Corel Draw. Same result. I get no logs/gcode errors. This also happens in arcs. Italicized letters get sloppy. I'm running current versions of both CC and CM. Is CC generating bad code? CM mishandling it? Something else altogether?
Posts: 2
Participants: 2