@Jamied wrote:
Hey guys, I need to know what I can do about this.
Whenever I start a job in carbide motion, right after I hit "run", the z axis plunges down, then it prompts me to insert the bit for the job (which I already have). Now, it hasn't hit my material yet, but I'm scared it may. Also, this seems very counter intuitive because even if I wanted to do a tool change, a) it happens at the x,y, job zero and b) it drops so low, that changing the bit would not be possible anyway.
I'm sure this is something simple for you guys, so, please help me out if you can.
Posts: 4
Participants: 2