@vik wrote:
I ran some quick jobs in aluminum using Carbide Create. I used the feeds and speeds in the table from the website for aluminum. The plunge rate that is suggested is 1", so that's what I used.
After the machine does its homing and tool height measurement, it goes to the position for the first plunge, and then is plunging down from the z-height max extents.... at... 1"... per... minute... which takes 3-4 minutes to get down to the thin sheet of aluminum I'm cutting. Why not go to the retract height that you can set in the carbide create software at a fast pace, and then plunge down at the slower rate? I had to run a few jobs on different pieces, and it was not fun watching it do this. Its a simple fix in the g-code I agree, but can this be addressed in the next rev? Or someone please explain the logic of this?
Posts: 1
Participants: 1