@starzen wrote:
Have started using my new SO3XL and did a number of test projects
Today i did another project. A name v carved, some texture and a 3D carving of an eagle head
All seemed to work fine until about 75% of the eagle head was completed. At that point it started stuttering. It was still carving properly but instead of doing nice motions it would stutter.
After it finally finished i decided to run the job again (without a bit) and it was stuttering from the beginning
Then i closed carbide motion and restarted it and started the same job again. this time it finished without the stuttering
any idea? Would be a pain to have this happen in an actual project that now takes ten times as long to finish
thks
Mike
Posts: 1
Participants: 1