@idank wrote:
Hi folks, I'm trying to cut this shape:
On the Nomad and running into difficulties. The end goal is to use aluminum but I can't get it right with hard wood so let's start there. The desired thickness is 4mm, with width / height at the max that can fit in the Nomad (20cm I believe). I tried screwing the corners to the waste board, and also putting a screw in the middle, but once the drill got towards the bottom of the stock, the little arms snapped because they're pretty thin, around 10mm closest to the center.
I thought I'll try putting supports between the arms at various points, but then I'm not sure how I'll get them off once it's done.
Any tips how to go about this?
Posts: 11
Participants: 4
