@JohnE wrote:
The last week and a half have produced more problems than finished products. I discussed some of those issues here:
I was finally able to flash back to 0.9 and have been using the machine with this firmware. Every time I flash to 1.1, it tells me to check the safety door, which is non-existent on my S3XXL. I am hearing from support that this might be related to a faulty pull-up resistor, but that's all I know so far.
I ran the S3 just fine for a night, but now I have a brand new problem: my y-axis limit switch light won't turn off. Doesn't matter if I trigger the switch manually, remove the connector from the board entirely, or even re-flash the firmware, the LED remains on and the software reports that a hard limit has been reached. I'm going to try and use the machine with limits turned off while I wait to hear back from C3D. Completely at a loss, though, so I'd be curious to hear if anyone else has seen the limit switch issue before.
Posts: 1
Participants: 1