@trichardson wrote:
I apologize if this has been posted before. I ran a couple of searches before posting for what it's worth.
I just received my machine and I'm running the 1st tutorial (the wrench). I've run it several times on the same piece of material and the spindle stops spinning a couple of seconds after the plunge. As an experiment, I set the Z a half inch above the stock and ran the program and the spindle never stopped. BTW, I don't think the tool's loose in the collet. I was watching for that and I'm 90% sure the entire spindle stops spinning (belt and all).
Any help would be appreciated. I'd hate to break it so soon. I can probably post a video if that would help.
Tom
Posts: 4
Participants: 2