@Woodmd wrote:
I hope that caught someones attention!
I was running a project yesterday, a toy camel, when I think my Shapeoko 3 came alive. Could this be the harbinger of SkyNet?
Merrily it was routing out the profile almost done when it decided to sink the 1/8 inch bit no where close to the pattern. It proceeded to sever the hind legs and disembowel the camel.
After shutting down, putting the camel out of it's misery, I checked the machine.
No stray pieces of wood blocking the gantry movement.I use CamBam for design, simulate with Cutmill, and run with Carbide motion.
Any thoughts or are we seeing the rise of the machines?
Not a conspiracy theorist, just a movie fan.....
John
Posts: 2
Participants: 2