Quantcast
Channel: Carbide 3D Community Site - Latest topics
Viewing all articles
Browse latest Browse all 25357

Tool Library Problem

$
0
0

@Signdude wrote:

I've searched the forum but can't seem to find an answer for my problem.

I can add new tools and later edit them. I cannot edit any of the existing tools, 101, 102, 111, 112, 201, 202. No matter whether I double click the tool or right click then select Edit. Neither the "OK" nor "CANCEL" are visible in the editing pane. I can type over existing entries but have no way to say OK.

I've added an 1/8" Ball Mill with 3 Flutes as 103. I've added both a 90 and 60 degree Vee Mill as 301 and 302 respectively. No problem. And as I said, I can edit any of those.

Perhaps someone could straighten me out on LOC and Flute Length. I was under the impression they were the same and the Flute Length determined the Length Of Cut.

On another issue... the LIbrary reports both the 201 and 202 1/4" end mills have a Flute length of .375 yet the labels on my new ones state .75 LOC and actually measure closer to 1". And additionally, in both cases the Library says they are 2 Flutes yet the new ones are 3 Flutes. I'll be happy to add them as 203 and 204 with the Label information if that's correct. But, either way, a .375 Flute length seems incorrect on the existing 201 and 202.

Sorry... one more thing. The 103 that I added appears at the bottom of the Library. Is there no way to sort or reorder by Tool Number???

I would appreciate any light someone might shed on this for me.

Thanks,
Bill

Posts: 1

Participants: 1

Read full topic


Viewing all articles
Browse latest Browse all 25357

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>