@spasmfingers wrote:
I posted a few weeks ago on pretty much the same problem, and was told to tighten the hex screws in the tiny holes on each motor. This helped immensely, I have successfully milled copper.
The Z axis has started giving under pressure again and my tool is stripped (I don't understand why these have to be so tiny) I'm ordering another tool which I'm sure will fix this issue, but this giving is a problem because it ruins my piece, wasted my time, and copper is not cheap.
Is there any upgrade I can do to keep my machines motors from giving? Looking for anything from small fixes like the tightening, to even replacing the motors, or replacing the belts with better ones, I just don't know what exactly I should do.
Posts: 3
Participants: 2